|
|
|
|
|
1. DESCRIPTION Antel
Brickwork Cleaner is a blend of acid and non ionic wetting agents, specially
designed for the rapid solubilisation of hydraulic
cements. The product provides for the
effective, efficient and easy cleaning of all brickwork, concrete spillage
and plant. It
removes the surface contamination and restores the surface to its original
shade. 2.
USES For the
removal of mortar stains, concrete runs, hardened concrete from cement
mixers, wheelbarrows, shovels, shuttering, scaffolding etc. Also can be used for the general cleaning
of brickwork, tile, concrete and stone surfaces. Also ideally suitable for cleaning asbestos
tiles, particularly where algae is present. 3. PACKAGING 5 litre
and 25 litre non returnable containers. 4.
STORAGE
Store
in cool, dry, well ventilated conditions in original containers. Protect from freezing. Keep
out of reach of children. Shelf
life - indefinite. 5.
USAGE RATE Coverage
is approximately 20 - 30 square metres per 5 litres dependent on the porosity
of the surface and the degree of contamination. 6.
HEALTH & SAFETY Caution
- Corrosive poison Antel
Brickwork Cleaner has an acid base and much care must be taken as imitation
to the skin and eyes can occur. It is
harmful by inhalation and irritating to the respiratory tract. If in contact with the eyes flush with
water for at least 15 minutes and obtain medical attention urgently. Prolonged or repeated contact with the skin
can cause severe irritation. Harmful
if taken internally - seek medical attention immediately. DO NOT
INDUCE VOMITING. Keep containers tightly closed when not in use. Wear suitable protective clothing when in
use. Do not
let washing down water contaminate ponds or waterways. Keep
out of reach of children. |
7.
SURFACE PREPARATION & APPLICATION Brickwork Initially
it may be necessary to remove concrete spillage by chipping taking care to
avoid damaging the surface. Stubborn
mortar stains may require wire brushing whilst the cleaner is on the surface. Concrete
Plant. If
concrete/cement is hardened it may be necessary to wire brush whilst the
cleaner is on the surface or alternatively remove the excess prior to
application taking care to avoid damaging the surface. Application The
cleaner should be applied and washed off after a few minutes. Long periods should not pass between
application and washing off, especially in hot weather. Do not allow the cleaner to dry on the
surface. Residual
staining is often due to inadequate washing down. Brickwork. Apply
liberally to contaminated surfaces by brush.
Leave for a few minutes and then wash off with clean, cold water,
preferably by hose. Always try a test
patch first to ensure no attack on the mortar joints occur. If attack does happen, dilute the cleaner
with clean cold water. Concrete
Plant Apply
liberally to contaminated surfaces by brush.
Leave for a few minutes then thoroughly wash off with clean cold
water, preferably by hose. Subsequent
treatment with mould oil or grease will prevent rust reforming. Do not
use on non ferrous metals such as galvanised, zinc, aluminium etc. |
|
Antel Ltd, 3.5 Central Point, Kirpal,