|
|
|
|
|
Non Slip Aggregates are available in three grades:- FINE MEDIUM COARSE
The choice of grade is determined by the use for the
finished surface. APPLICATION Non slip aggregates are applied in the same way for
all systems. Firstly a single application of the coating is
applied to a carefully prepared surface.
While this is still wet and active the non-slip aggregate is ‘broad
cast’ evenly over the surface. An alternative method is to use a ‘pepper box’
and again evenly distribute the non slip aggregate. Do not over apply the aggregate as this is counter
productive and will leave a surface which is very difficult to clean. Allow the first coat to become tack free. Use a vacuum cleaner to remove any excess aggregate
that has not adhered to the first coat. Apply a further coat to the vacuumed area in order
to lock in the non slip aggregate. A
third coat may be required if the cover over the first coat and aggregate
leaves a too harsh surface. NOTE Preparation is of vital importance Lighter application result in optimum
performance. |
|
|
Antel Ltd, 3.5 Central
Point,