Panel Adhesive

Technical Data Sheet

1. DESCRIPTION

Antel Panel Adhesive is a high strength, one part adhesive which will bond a wide variety of materials either to themselves or each other.

2.  USES

Suitable for use with many commonly used construction and fabrication materials such as glass, steel, masonry, timber and aluminium.

Ideal for bonding most types of wall cladding and battens direct to internal wall surfaces without other fastenings and for fixing rigid PVC architraves and skirtings to wall surfaces; stair nosings to concrete and wood stairs and carpet grippers to sub floors.

3.  PACKAGING                    

380 ml plastic cartridge complete with nozzle.  Packaged 24 per box.

4. COLOUR

White.

5.  STORAGE                        

• Highly flammable.  Keep away from sources of ignition.
• Store in cool, dry conditions.
• Protect from freezing.
• Keep out of reach of children.

6.  HEALTH & SAFETY

On contact, uncured Panel Adhesive will irritate the eyes.  In case of contact, remove the sealant and flush eyes thoroughly with water. 

If irritation persists seek medical attention.  Avoid skin contact. Ensure adequate ventilation during application.

KEEP OUT OF REACH OF CHILDREN.

Keep away from sources of ignition - NO SMOKING.

In case of fire use dry powder, carbon dioxide, foam or earth.  Never use water.

7.  APPLICATION

7.1 Preparation

Surfaces must be clean, sound, dry and free from dust and any loose material. Paint should be removed where the adhesive will make contact.  New concrete or plaster should be allowed adequate time to dry and porous or friable surfaces should first be primed with a dilute solution of contact adhesive and allowed to dry.

7.2 Application

Trim the nozzle to the desired angle/bead size, and puncture the internal seal at base of nozzle with a long nail/rod.  Using an extruder gun, apply a continuous bead approximately 6 mm (¼ inch) diameter.  Press surfaces firmly together immediately.

Bonding Flat Panels - Apply a bead around the edge of the panel (50 mm from the edge) and in horizontal lines at approximately 450 mm centres.  Press the panel firmly to the wall to ensure adequate transfer and leave to set.  A firm bond is achieved in one hour.

NB. If the panel is warped apply the adhesive as described and then press the panel firmly to the wall surface and pull away immediately.  This will achieve an adhesive transfer and allow solvent evaporation.  After 10-20 minutes the panel may then be bonded into position and a contact bond achieved.