Salt Arrest

Technical Data Sheet

1.  DESCRIPTION

Antel Salt Arrest is a two part, highly penetrative epoxy sealer.  Specifically designed to combat the difficult problem of salt migration through friable building  materials.  This product also imparts excellent binding and consolidation properties.

2.   PACKAGING       

Available in 1 litre, 2.5 litre and 5 litre sizes.  A two part product marked Pack A & Pack B.

3.   STORAGE

HIGHLY FLAMMABLE.  Salt Arrest has a flash point of -1°C.  Store in cool, dry conditions away from all forms of ignition.

Keep out of reach of children.

4. COVERAGE

Coverage rate depends entirely on the porosity of the surface to be treated.  Guide figures as follows:-

10 square metres / 5 litres

2 square metres / 1 litre

5.   HEALTH & SAFETY       

Highly Flammable Liquid.

Use only in well ventilated areas.  If ventilation is difficult it is highly recommended that fresh air breathing apparatus be worn.   Continue to ventilate the area treated after completion of work.  Do not allow a build up of solvent vapours since these can be ignited and cause explosion.

Eye and skin protection must be worn.

Splashes in the eyes should be rinsed with copious amounts of water and medical attention should be obtained immediately.

Splashes on the skin can be removed using a suitable resin removal cream.

Handling:  Avoid contact with the eyes and skin.  Use of PVC gloves, goggles and protective clothing is recommended.

Storage:    Store in cool dry conditions in original containers. Protect from freezing. Keep out of reach of children.

6.   INSTRUCTIONS FOR USE

6.1 PREPARATION.

Antel Salt Arrest is designed to prevent salt migration through building masonry.  It must be applied to the base of masonry and not to renders or coatings applied to masonry.

Remove all forms of contamination and any weak material prior to application.

6.2 MIXING.

Open both containers taking care not to damage the screw thread of the rectangular tin.  Remove the inner seal of the larger tin.  Pour the entire contents of the smaller container into the larger one and replace the lid tightly.  Shake the container vigorously for about five minutes.

6.3 APPLICATION.

Application is best carried out using a brush.  The mixed material should be flooded onto the prepared surface and worked well in.   Apply each application until refusal.  Do not allow the previous application to dry before applying further material.  Continue applications until the surface will not accept any more material.

6.4 DECORATION.

If required further decoration or protective coatings can be applied to the treated areas.   This action is best carried out within two days of the treatment.

6.5 POT LIFE

The mixed material has a very long pot life and can be used up to two days after mixing provided that the container is kept resealed after taking out enough product for each application.