Antel Limited
Unit 3.5   Central Point    Kirpal Road    Portsmouth   PO3 6FH   United Kingdom
Telephone +44 (0) 23 9285 6110    Fax +44 (0) 23 9281 1426     Email : mail@antel-uk.co.uk
 
 

 

Descaler

Technical Data Sheet

1. DESCRIPTION/USE

Antel   Descaler is an acidic solution containing surfactants for the removal of cementitious material by chemical reaction.  Also effective on calcinated clays, lime etc.

2.   PACKAGING  

5 litre and 25 litre non returnable containers.

3.   STORAGE    

Store in cool, dry, well ventilated conditions in original containers.  Protect from freezing.

Keep out of reach of children.

Shelf life - indefinite.

4.   USAGE RATE

Descaler can be used direct from the container although great care should be taken when in its concentrate form.

A dilution rate of 1 part Descaler to 3 parts water is recommended.

ALWAYS ADD THE DESCALER TO THE WATER

Coverage is approximately 15  - 25 square metres per 5 litres of diluted fluid dependent on the porosity of the surface and the degree of contamination.

5.   HEALTH & SAFETY

Caution - Corrosive

Antel Descaler has an acid base and much care must be taken as imitation to the skin and eyes can occur.  It is harmful by inhalation and irritating to the respiratory tract.  If in contact with the eyes flush with water for at least 15 minutes and obtain medical attention urgently.  Prolonged or repeated contact with the skin can cause severe irritation.  Wash contaminated skin immediately. 

Harmful if taken internally - seek medical attention immediately.   DO NOT INDUCE VOMITING. Keep containers tightly closed when not in use.  Wear suitable protective clothing when in use.

Do not let washing down water contaminate ponds or waterways.

Keep out of reach of children.

6.   SURFACE PREPARATION & APPLICATION

Preparation

Remove any loose material, dust etc. before application

Mixing

Apply direct or diluted as previously shown.

Application

Put the Descaler in to a suitable receptacle i.e watering can and sprinkle on to the concrete at an even rate of approximately 20 metres square per 5 litres of mix.  When the surface run has ceased, wash down with copious amounts of clean water. Long periods should not pass between application and washing off, especially in hot weather.  Do not allow the Descaler to dry on the surface.

Cure Schedule - Not applicable

Cure properties - Not applicable

Only use none metallic containers and mixing equipment

For more information on this product or any other product in our range please contact :
 
Antel Limited
Unit 3.5   Central Point    Kirpal Road    Portsmouth   PO3 6FH   United Kingdom
Telephone +44 (0) 23 9285 6110    Fax +44 (0) 23 9281 1426     Email : mail@antel-uk.co.uk
http://www.antel-uk.co.uk