Brickwork Cleaner

Technical Data Sheet

1. DESCRIPTION

Antel Brickwork Cleaner is a blend of acid and non ionic wetting agents, specially designed for the rapid solubilisation of hydraulic cements.  The product provides for the effective, efficient and easy cleaning of all brickwork, concrete spillage and plant.

It removes the surface contamination and restores the surface to its original shade.

2.   USES

For the removal of mortar stains, concrete runs, hardened concrete from cement mixers, wheelbarrows, shovels, shuttering, scaffolding etc.  Also can be used for the general cleaning of brickwork, tile, concrete and stone surfaces.  Also ideally suitable for cleaning asbestos tiles.

3.   PACKAGING  

5 litre and 25 litre non returnable containers.

4.   STORAGE    

Store in cool, dry, well ventilated conditions in original containers.  Protect from freezing.

Keep out of reach of children.

Shelf life - indefinite.

5.   USAGE RATE

Coverage is approximately 20  - 30 square metres per 5 litres dependent on the porosity of the surface and the degree of contamination.

6.   HEALTH & SAFETY

Caution - Corrosive poison

Antel Brickwork Cleaner has an acid base and much care must be taken as imitation to the skin and eyes can occur.  It is harmful by inhalation and irritating to the respiratory tract.  If in contact with the eyes flush with water for at least 15 minutes and obtain medical attention urgently.  Prolonged or repeated contact with the skin can cause severe irritation.  Wash contaminated skin immediately. 

Harmful if taken internally - seek medical attention immediately.   DO NOT INDUCE VOMITING. Keep containers tightly closed when not in use.  Wear suitable protective clothing when in use.

Do not let washing down water contaminate ponds or waterways.

Keep out of reach of children.

7.   SURFACE PREPARATION & APPLICATION

Brickwork

Initially it may be necessary to remove concrete spillage by chipping taking care to avoid damaging the surface.  Stubborn mortar stains may require wire brushing whilst the cleaner is on the surface.

Concrete Plant.

If concrete/cement is hardened it may be necessary to wire brush whilst the cleaner is on the surface or alternatively remove the excess prior to application taking care to avoid damaging the surface.

Application

The cleaner should be applied and washed off after a few minutes.  Long periods should not pass between application and washing off, especially in hot weather.  Do not allow the cleaner to dry on the surface.

Residual staining is often due to inadequate washing down.

Brickwork.

Apply liberally to contaminated surfaces by  brush.  Leave for a few minutes and then wash off with clean, cold water, preferably by hose.  Always try a test patch first to ensure no attack on the mortar joints occur.  If attack does happen, dilute the cleaner with clean cold water.

Concrete Plant

Apply liberally to contaminated surfaces by  brush.  Leave for a few minutes then thoroughly wash off with clean cold water, preferably by hose.  Subsequent treatment with mould oil or grease will prevent rust reforming.

Do not use on non ferrous metals such as galvanised, zinc, aluminium etc.