Antel Limited
Unit 3.5   Central Point    Kirpal Road    Portsmouth   PO3 6FH   United Kingdom
Telephone +44 (0) 23 9285 6110    Fax +44 (0) 23 9281 1426     Email : mail@antel-uk.co.uk
 
 

 

Water Based Epoxy Floor Paint

Technical Data Sheet

1. DESCRIPTION

Antel water based epoxy floor paint is a two pack pigmented floor paint recommended for use over high alumina concrete and other fresh concrete and alkaline surfaces such as chalk, marble and limestone chips..

2. USES

Offices, factories, abattoirs etc.

3. PACKAGING

1 litre, 2.5 litre and 5 litre cans.

4. COLOUR

Specific colours can be supplied upon request, within reason. Dark colours are currently recommended as UV stability information is unavailable at present.

5. USAGE RATE

5 litres will cover 30m² (substrate - primed paving slab)

6. SHELF LIFE

12 months in sealed container..

7. INSTRUCTIONS FOR USE

7.1 Preparation:

Surfaces must be clean, dry and free from all foreign matter such as grease etc. Loose or weak flaking material should be removed. Best results are obtained by the use of an appropriate Antel cleaner.

Due to the porosity of substrates, it is important to apply a primer to the substrate in order to seal it. Antel=s water based epoxy floor primer has been especially developed for this purpose.

7.2 Mixing:

Empty the entire contents of Pack 'B' into Pack 'A' and stir for 3 minutes. Add water in increments to adjust to desired viscosity and agitate for a further 3 minutes until uniform.

7.3 Application:

Having allowed the previously applied Antel Floor Primer to cure, apply by brush or roller. Two coats of floor paint are recommended, allow 5 hours between primer and first coat and 5 hours between first and second finish coat, depending on temperature and relative humidity of the surrounding area. (Coatings should be tack free between applications).

7.4 Curing:

Tack Free Through Cure

at 20°C 65% RH 5 hours 10 hours
at 8°C, 65% RH 12 hours 24-26 hours

Pot life at 20°C 1.5 hours
Pot life at 10°C 2.5 hours

7.5 Cleaning Tools:

Clean tools immediately after use with clean water

8. TYPICAL PERFORMANCE PROPERTIES

Taber abrasion Index (MG) 42 per 1000 cycles.

Chemical Resistance:

Resistant to most dilute alkali systems e.g 10% Sodium Hydroxide but will NOT withstand acidic attack e.g. Hydrochloric Acid.

Resistance to vehicular traffic - Good. Resistance to pedestrian traffic - Excellent.

For more information on this product or any other product in our range please contact :
 
Antel Limited
Unit 3.5   Central Point    Kirpal Road    Portsmouth   PO3 6FH   United Kingdom
Telephone +44 (0) 23 9285 6110    Fax +44 (0) 23 9281 1426     Email : mail@antel-uk.co.uk
http://www.antel-uk.co.uk