|
Fungicidal Wall Solution
Technical Data Sheet
1.
DESCRIPTION
Antel
Fungicidal Wall Solution water dilutable concentrate is one of the range of
treatments specially formulated for the remedial industry, to
provide a material for the effective treatment of fungal attack on
masonry.
2.
USES
Designed
especially for the treatment of masonry, walls and roof tiles for
the effective removal of fungicide and moss growth (on roofs).
3.
PACKAGING
Available
in 1 litre size.
15
x 1 litre plastic containers per box.
4.
USAGE RATE
1
litre of diluted fluid will treat approximately 2 - 3 square
metres depending on porosity and surface conditions.
5.
STORAGE
Store
in secure, cool, dry, well ventilated conditions in original
closed containers. Keep out of reach of children.
Protect
from freezing.
6.
HEALTH & SAFETY
If
inhaled remove to fresh air immediately.
Irritating to eyes and skin.
Precautions are necessary in handling and application, to
avoid bodily contact due to splashing, spillage or leakage.
The normal precautions (use of goggles/visor, gloves,
protective clothing and the prompt removal of contaminated
clothing) should be observed with particular rigour especially
when Fungicidal Wall Solution is in its concentrate form.
Should
the fluid come into contact with the skin it must be washed off
promptly.
If
in contact with the eyes, flush copiously with water and seek
medical attention.
7.
DILUTION
1
PART CONCENTRATE : 24 PARTS WATER
(1
litre of Fungicidal Wall Solution makes up to 25 litres)
8.
MIXING
Mix
the contents of the concentrate Fungicidal Wall Solution with water in a 25
litre container. Close
the cap tightly and shake to thoroughly mix the solution.
The emulsion is easily formed and stable for a complete
working day. Mix only enough material as will be used for 2 - 3
days after initial mixing. (It is preferable to only mix
sufficient on a daily basis).
9.
APPLICATION
Apply
Fungicidal Wall Solution by brush or by spray to the affected areas.
For the effective removal of fungicide and moss growth on
roofs, apply to the affected areas and allow to remain in contact
for a period in excess of one hour but not more than three hours.
Power wash the treated areas to remove the neutralised
material. Apply a
further coat of the solution and allow to dry.
|
