|
Epoxy Grout Aggregate
Filled
Technical Data Sheet
1.
DESCRIPTION
Antel
Aggregate Filled Grout is a three component, high strength epoxy
resin system formulated for use in the installation of high
strength anchors, support of base plates or any civil or
mechanical engineering situations involving high dynamic loads, eg
tie bars, bearing pads etc.
2.
USES
1.
Civil engineering or structural grout
2.
Vibrating resistance
3.
Impact resistance
3.
PACKAGING
1
litre, 2.5 litres, 5 litres.
4.
USAGE RATE
2.5
litres will fill a void 50 mm x 250 mm x 200 mm
5.
INSTRUCTIONS FOR USE.
5.1
Preparation:
Concrete
surfaces should be clean and free from all loose material.
All steel and machine beds should be free from grease and
loose rust. In
most cases Antel Aggregate Filled Grout does not require a primer.
5.2
Mixing:
Mix
the entire contents of pack 'B' with pack 'A' stirring for three
minutes. Slowly add
the blended aggregate to the binder in the bucket and mix until
uniform.
5.3
Application:
Once
mixed the product can be poured into the hole, bed plate etc.
allowing for a slight excess at the upper perimeter of the hole or
shuttering around the bed plate.
5.4
Cure schedule:
Initial
cure @ 25°C
4 hours
Full
cure @ 25°C
48 hours
6.
CURE PROPERTIES
Compressive
strength: E60
N/mm²
Tensile
strength:
7 days/20NC -15N/mm²
Tensile
bond-steel:
7 days/20NC - 12N/mm²
7.
LINEAR SHRINKAGE
0.009%
8.
SHELF LIFE
12
months in original containers.
9.
TOOL CLEANING
All
tools etc should be cleaned with Antel Cleaning Solvent
immediately after use.
|
