|
PU Woodworking Adhesive
Technical Data Sheet
1.
DESCRIPTION
Antel
P U Woodworking Adhesive is a moisture curing, one part,
Polyurethane adhesive specifically designed for use in the
woodworking industry. It
will bond a wide variety of materials including wood, plastics and
metals.
2.
SURFACE PREPARATION
Materials
to be bonded should be clean and free from dust, grease and other
contaminants. Metals
should be stored in a warm environment prior to bonding to avoid
chilling the glue line, which leads to extended cure times.
Most
pre-finished metals have backing coats which are well suited to
bonding.
Some
grades of Aluminium, Galvanised Steel and plastics can be
difficult to bond and may require the use of a primer.
A test panel should always be prepared when new materials
are to be used to establish the adhesive compatibility.
3.
PACKAGING
500
ml and 1 litre containers.
Adhesive
is Brown in colour
4.
COVERAGE
1
Litre will cover up to 12.5 m²
5.
STORAGE
Keep
containers tightly closed in dry conditions.
Avoid product temperatures above 25°C and below 5°C.
Ensure adequate ventilation in the working area.
No
special measures against fire or explosion required.
Flash
point above 150°C.
6.
APPLICATION
Apply
the adhesive to wood joint via squeezy bottle, brush or scraper.
Position the joint and tightly clamp until the adhesive has
cured. If
substrates to be bonded are moisture free, i.e. metals, plastics,
a light moisture overmist may be required to obtain full cure.
Whilst curing the adhesive may foam.
When fully cured, the foam can easily be sanded.
7.
SPECIAL FEATURES
Can
be used to bond oily woods e.g. teak, oak.
It
is recommended that any surface oils are removed before bonding.
Bonds
wood treated with caustic soda.
Will
take most stains and varnishes.
Good
gap filling properties.
Waterproof
bond achieved when fully cured.
Solvent
free.
Apply
to one surface only
Handleable
in one hour
24
hours full cure
Flexible bond
Chemical
and heat resistant
8.
SHELF LIFE
3
months
|
